Engine Coolant Temperature Sensor On Radiator Outlet G83 , Removing And Installing - Volkswagen Golf 2015 Repair Manual

– Loosen the hose clamp -2-.
– Remove bolt -1-, push the left air guide pipe left.
– Disconnect the connector -1-.
Note
Place a cleaning cloth underneath, to catch coolant leaking
♦
out.
To prevent coolant loss, immediately insert the new Engine
♦
Coolant Temperature Sensor - G62- in the connection.
– Remove the bolts -2-, and remove the Engine Coolant Tem‐
perature Sensor - G62- -3-.
Installing
Install in reverse order of removal. Note the following:
Note
Replace the O-rings.
– Check the coolant level. Refer to
Tightening Specifications
♦ Refer to
⇒ 2.3 Overview - Engine Coolant Temperature Sensor , page
228 .
♦ Refer to ⇒ 3.1 Overview - Air Filter Housing , page 293
2.11 Engine Coolant Temperature Sensor on
Radiator Outlet - G83- , Removing and
Installing
Removing
• The engine is cold.
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
⇒ page 218 .
.
Golf 2015 ➤ , Golf Variant 2015 ➤
2. Coolant Pump/Thermostat
239