Volkswagen Golf 2015 Repair Manual page 151

– Lightly push on the cylinder head cover by hand and while
doing this turn the camshaft slightly until the cylinder head
cover lays free of tension on the cylinder head.
– Replace the cylinder head cover bolts.
– Tighten the bolts in several steps, tightening sequence. Refer
to
⇒ Fig. Cylinder Head Cover Tightening Sequence ,
page 135 .
Note
Pay attention that the cylinder head cover is not tilted.
– Turn the intake camshaft with the Adapter - T40266- in the
direction of -arrow A- until the markings -1 and 2- align. Push
the Camshaft Lock - Component 2 - T40271/2- in the chain
sprocket splines in direction of -arrow B-.
– Turn the exhaust camshaft with the Adapter - T40266- in the
direction of -arrow A- until the markings -1 and 2- align. Push
the Camshaft Lock - Component 1 - T40271/1- in the chain
sprocket splines in direction of -arrow B-. The mark -2- is offset
slightly to the right.
– Turn the crankshaft on the hex fitting to the Top Dead Center
(TDC) point . In the TDC point flat area -1- is upward.
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Golf 2015 ➤ , Golf Variant 2015 ➤
143
4. Valvetrain