Golf 2015 ➤ , Golf Variant 2015 ➤
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Note
The lubrication system could be plugged with excess sealant. Do
not apply sealant bead thicker than indicated.
– Apply the silicone sealant on the clean sealing surface of the
upper oil pan section as shown -arrows-.
•
Sealant bead thickness: 2 to 3 mm.
– Apply the silicon sealant, as shown in the illustration
-arrows-, between the cylinder block and the timing chain
guard lower section.
Note
The oil pan upper section must be installed within 5 minutes
♦
after application of silicone sealant.
The sealant bead may not be thicker than specified, otherwise
♦
excess sealant could enter the oil pan and clog the oil intake
tube.
•
On the transmission side, the upper part of the oil pan and the
crankcase must align.
– Position the upper section of the oil pan immediately and tight‐
en the bolts, tightening sequence. Refer to Tightening se‐
quence. Refer to
⇒ Fig. Oil Pan Upper Section - Tightening Sequence , page
181
.
– Install the bolts -arrows-. Tightening specifications -item 16-
⇒ Item 16 (page 105)
– Install the rear sealing flange. Refer to
⇒ 2.3 Sealing Flange, Removing and Installing, Transmission
Side , page 59
.
– Install the oil pump. Refer to
⇒ 1.5 Oil Pump, Removing and Installing , page 188
– Insert the new oil baffle and attach it. Tightening specification.
Refer to -item 7-
⇒ Item 7 (page 180)
– Install oil pan lower section. Refer to
⇒ 1.3 Oil Pan Lower Section, Removing and Installing , page
182
.
Assemble in reverse order of disassembly.
– Fill with engine oil and then check the level. Refer to ⇒ Main‐
tenance ; Booklet 36.1 ; Procedure Descriptions; Engine Oil,
Draining, Replacing Oil Filter, and Filling .
Tightening Specifications
♦ Refer to
⇒ 1.1 Overview - Oil Pan/Oil Pump , page 179
1.5
Oil Pump, Removing and Installing
Special tools and workshop equipment required
♦ Elbow Assembly Tool - T10118-
188
Rep. Gr.17 - Lubrication
.
.
.
.