Volkswagen Golf 2015 Repair Manual page 191

Removing
– Remove the noise insulation -1-. Refer to ⇒ Body Exterior;
Rep. Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
– Place the Used Oil Collection and Extraction Unit -
SMN372500- under the engine and drain the engine oil.
Note
Follow all waste disposal regulations!
– Remove the bolts -1 through 20- and remove the oil pan.
– Remove the bolt -1- and remove the oil baffle -2-.
Installing
– Install a new oil baffle. Tightening specification. Refer to
-item 7- ⇒ Item 7 (page 180)
– Tighten the new bolts -1 through 20- in two stages in the se‐
quence shown:
Step
1. Bolts -1- through -20-
2. Bolts -1- through -20-
– Fill with engine oil and then check the level. Refer to ⇒ Main‐
tenance ; Booklet 36.1 ; Engine; Draining; Oil Filter, Replac‐
ing; Engine Oil, Filling .
1.3.2 Oil Pan Lower Section, Removing and
Installing, Metal Oil Pan
Special tools and workshop equipment required
♦ Used Oil Collection and Extraction Unit - SMN372500-
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
.
Tightening Sequence and
Tightening Specification
Pre-tighten to 8 Nm
90° additional turn
Golf 2015 ➤ , Golf Variant 2015 ➤
1. Oil Pan/Oil Pump
183