Volkswagen Golf 2015 Repair Manual page 24

Golf 2015 ➤ , Golf Variant 2015 ➤
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
– Remove the bolts -arrows- for the engine mount (about two
turns).
– Remove the fan shroud. Refer to
⇒ 4.5 Fan Shroud, Removing and Installing , page 249
– Open the clamp -1 and 2- and remove the air duct hose.
– Seal the open lines and connections with clean plugs from the
Engine Bung Set - VAS6122- .
– Free up the coolant hose -3-.
– Remove the bolts -arrows-.
– Loosen the hose clamp -2-.
– Disconnect the connector -1- on the Charge Air Pressure Sen‐
sor - G31- .
– Remove the right air guide pipe.
– Before removing the ribbed belt, mark the running direction
with chalk or a felt-tip pen for reinstallation.
– Pivot the tensioner clockwise in direction of -arrow- to release
the tension on the ribbed belt.
– Remove the ribbed belt from the A/C compressor ribbed belt
pulley and release the tension on the tensioning device. If
necessary, remove the Locking Pin - T10060A- .
CAUTION
Danger of frostbite from refrigerant.
– Do not open the A/C system refrigerant circuit.
16
Rep. Gr.10 - Engine Assembly
.