Volkswagen Golf 2015 Repair Manual page 311

❑ Lubricate the high pressure line with engine oil
❑ Do not install a tensioned high pressure line (pay attention to cleanliness).
11 - Fuel Line Connections
❑ 20 Nm
❑ On vehicles without multiport fuel injection, a sealing plug is installed
12 - Clamp
❑ Replace after removing
13 - Bolt
❑ 5 Nm
14 - Fuel Line
❑ Fuel line to the intake manifold fuel injector fuel rail
15 - Vacuum Diaphragm for Channel Separating Plate
16 - Vacuum Hose
17 - Intake Manifold Runner Control Valve - N316-
18 - Intake Manifold Sensor - GX9-
❑ Consists of:
Intake Air Temperature Sensor - G42-
Manifold Absolute Pressure Sensor - G71-
19 - Bolt
❑ 5 Nm
20 - Intake Manifold
❑ Removing and installing. Refer to
21 - Intake Manifold Runner Position Sensor - G336-
❑ After replacing or removing and installing, the Intake Manifold Runner Position Sensor - G336- must be
adapted to the Engine Control Module - J623- using the ⇒ Vehicle diagnostic tester.
22 - Intake Manifold Nut
❑ 9 Nm
23 - Intake Manifold Bolts
❑ 9 Nm
24 - Seal
❑ Check and replace if damaged
25 - Low Fuel Pressure Sensor - G410-
❑ 15 Nm
❑ Must be bolted with the adapter -26-
❑ Removing and installing. Refer to
⇒ 5.4 Low Fuel Pressure Sensor G410 , Removing and Installing , page 318
26 - Adapter
❑ 15 Nm
❑ Must be bolted with the Low Fuel Pressure Sensor - G410-
❑ Replace O-ring
27 - O-Ring
❑ Replace after removing
28 - Clip
❑ For the locating point of the Low Fuel Pressure Sensor - G410- in the fuel rail.
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
⇒ 4.3 Intake Manifold, Removing and Installing , page 304
Golf 2015 ➤ , Golf Variant 2015 ➤
.
4. Intake Manifold
.
303