Oil Separator, Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Oil Separator - Tightening Sequence
– Tighten the bolts in the sequence -1 through 7-.
Bolts
-1 through 7-
3.2

Oil Separator, Removing and Installing

Removing
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ Seal - Oil Separator
♦ Seals - Oil Separator to Crankcase Hose
– Disconnect the ignition coil sensors connectors and remove
them from the ignition coils at the same time.
– Remove the ignition coils bolts 3, 4 , and remove the ignition
coils.
– Loosen the hose clamp -1- and remove the hose from EVAP
Canister Purge Regulator Valve 1 - N80- .
– Remove bolt -2- and then remove crankcase ventilation hose
-3- from oil separator.
– Remove the bolts -arrows- and the oil separator.
Installing
Install in reverse order of removal. Note the following:
Note
Always replace gasket and seals.
♦
♦ Secure hose connections with standard production clamps.
Refer to the Parts Catalog.
Tightening Specifications
♦ Refer to
⇒ 3.1 Overview - Crankcase Ventilation , page 195
196
Rep. Gr.17 - Lubrication
Tightening Sequence and Tor‐
que Specification
9 Nm.
.