Volkswagen Golf 2015 Repair Manual page 175

♦ Engine And Transmission Holder - VAS6095-
♦ Cylinder Head Tensioning Device - VAS6419-
Remove Valve Stem Seals
– Remove the camshafts. Refer to
⇒ 4.2 Camshaft, Removing and Installing , page 136
– Mark the allocation of the roller rocker lever and the hydraulic
adjusting elements so they can be installed again.
– If necessary, remove the roller rocker levers with the hydraulic
adjusting elements and place them on a clean surface.
– Insert the Cylinder Head Tensioning Device - VAS6419- in the
Engine And Transmission Holder - VAS6095- .
– Tension the cylinder head on the cylinder head tensioning de‐
vice, as illustrated.
– Connect the cylinder head tensioning device to the com‐
pressed air.
– Slide the air cushion with the lever -arrow- under the combus‐
tion chamber onto the valve stem seal that will be removed.
– Let enough compressed air flow into the air cushion until it
contacts the valve plate.
– Install the Valve Cotter Tool Kit - Guide Plate 19B -
VAS5161/19C- with the Valve Cotter Tool Kit Knurled Thumb
Screws M6 - VAS5161/12- as shown on the cylinder head.
– Insert the Punch - VAS5161/3- in the guide plate and loosen
the stuck valve retainers with a plastic mallet.
For Intake Side
– Install the Valve Cotter Tool Kit - Retainer - VAS5161/6- with
Valve Cotter Tool Kit - Guide Forks M6/M8 Threaded -
VAS5161/5- in the center thread of the Valve Cotter Tool Kit -
Guide Plate 19B - VAS5161/19B- .
– Place the Valve Cotter Tool Kit - Assembly Cartridge -
VAS5161/8- in the Valve Cotter Tool Kit - Guide Plate 19B -
VAS5161/19B- .
– Engage the Pressure Fork With Lever for Assembly Cartridge
- VAS5161/2- on the Retainer - VAS5161/6- .
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
.
Golf 2015 ➤ , Golf Variant 2015 ➤
167
4. Valvetrain