Volkswagen Golf 2015 Repair Manual page 84

Golf 2015 ➤ , Golf Variant 2015 ➤
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
– Pry out the seal in direction of -arrow A-.
– Clean the running and sealing surface.
– Coat the sealing surface of the balance shaft -2- with trans‐
mission oil.
– Push the seal -1- onto the balance shaft.
• Luftseite or ( Outside ) -arrow- must be readable from the
outside.
Note
The drive wheel bolt -2- has left-hand thread.
– Mount the Seal Installer, Intermediate Shaft - T10353/1- on the
shaft seal -1- and then tighten it all the way into the cylinder
block with the bolt -2-. Be careful not to tilt the shaft seal when
doing this.
– Install the toothed belt on the coolant pump. Refer to
⇒ 2.8 Coolant Pump Toothed Belt, Removing and Installing ,
page 235 .
– Fill with coolant. Refer to
76
Rep. Gr.13 - Crankshaft, Cylinder Block
⇒ page 218 .