Charge Air Pressure Sensor G31 , Removing And Installing; Charge Air System, Checking For Leaks - Volkswagen Golf 2015 Repair Manual

2.4 Charge Air Pressure Sensor - G31- ,
Removing and Installing
Removing
Caution
This procedure contains mandatory replaceable parts. Refer
to component overview prior to starting procedure.
Mandatory Replacement Parts
♦ O-ring - Charge Air Pressure Sensor
– Remove the noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
– Disconnect the connector -2-.
– Remove the bolts -1- and remove the Charge Air Pressure
Sensor - G31- from the air duct pipe.
Installing
Install in reverse order of removal. Note the following:
Note
Replacing the O-ring.
Tightening Specifications
♦ Refer to ⇒ 2.1 Overview - Charge Air System , page 264
♦ Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Noise Insulation;
Overview - Noise Insulation .
2.5

Charge Air System, Checking for Leaks

Special tools and workshop equipment required
♦ Turbo System Tester Kit - VAG1687-
♦ Turbo System Tester Kit - Adapter 10 - VAG1687/10-
♦ Turbo System Tester Kit - Adapter - VAG1687/14-
♦ Ultrasonic Tester - VAG1842S-
Procedure
– Loosen the hose clamps -1 and 2- and remove the air guide
pipe.
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
Golf 2015 ➤ , Golf Variant 2015 ➤
.
2. Charge Air System
269