Engine Coolant Temperature Sensor G62 , Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
– Remove the bolts -1 to 5-.
– Remove the Engine Temperature Control Actuator - N493-
from the centering pin and disconnect it from the engine oil
cooler.
Installing
Install in reverse order of removal. Note the following:
Note
Replace the seals and O-rings.
– Coat the new O-rings -4- with coolant.
– Make sure both centering pins are installed in the cylinder
block.
– Install the connection piece -2- into the engine oil cooler -1-.
– Push the Engine Temperature Control Actuator - N493- -3-
into the connection piece and onto the centering pins in the
cylinder block.
– Tighten the bolts for the Engine Temperature Control Actuator
- N493- . Refer to
⇒ Fig. Engine Temperature Control Actuator -N493- - Tight‐
ening Specifications and Sequence , page 225
– Install the coolant pump. Refer to
⇒ 2.7 Coolant Pump, Removing and Installing , page 232
– Fill with coolant. Refer to
Tightening Specifications
♦ Refer to
⇒ 2.1 Overview - Coolant Pump/Thermostat , page 223
♦ Refer to ⇒ 4.1 Overview - Intake Manifold , page 296
2.10 Engine Coolant Temperature Sensor -
G62- , Removing and Installing
Removing
• Engine is cold.
– Quickly open the coolant expansion tank cap -arrow- and re‐
lease any remaining pressure in the cooling system and then
close it again until it locks.
– Remove the air filter housing. Refer to
⇒ 3.2 Air Filter Housing, Removing and Installing ,
page 294 .
238
Rep. Gr.19 - Cooling System
.
⇒ page 218 .
.
.
.