Volkswagen Golf 2015 Repair Manual page 103

♦ Seal - Turbocharger to Engine
♦ Bolts - Cylinder Head
♦ Gasket - Cylinder Head
Note
Before installing the cylinder head the engine support and the
♦
engine mount are temporarily re-installed because the eyes
from the engine support bridge are secure on the cylinder
head.
When installing, secure all cable ties back to the same posi‐
♦
tions.
Close the open channels from the intake and exhaust tract with
♦
suitable plugs from the Engine Bung Set - VAS6122- .
– Remove the camshafts. Refer to
⇒ 4.2 Camshaft, Removing and Installing , page 136
– Reinstall the engine support and engine mount and tighten the
bolts hand-tight.
– Disengage the Engine Support Bridge - 10-222A- spindles.
– Drain the coolant. Refer to
⇒ 1.3 Coolant, Draining and Filling , page 217
– Remove front exhaust pipe with catalytic converter. Refer to
⇒ 2.2 Catalytic Converter, Removing and Installing ,
page 349 .
– Remove the Oxygen Sensor 1 before Catalytic Converter -
GX10- . Refer to
⇒ 8.2 Oxygen Sensor 1 before Catalytic Converter GX10 ,
Removing and Installing , page 333
– Remove the left and right bolts -arrow-.
– Unclip the air guide lower section -1- and remove.
– Loosen the hose clamp -2-, remove the air duct hose from the
charge air cooler.
– Seal the open lines and connections with clean plugs from the
Engine Bung Set - VAS6122- .
Engine Mechanical, Fuel Injection and Ignition - Edition 04.2015
.
.
.
Golf 2015 ➤ , Golf Variant 2015 ➤
95
1. Cylinder Head