Start Analysis - Micromeritics Gemini VII 2390a Operator's Manual

Gemini VII

Start Analysis

Ensure the analyzer compartment door is closed before beginning an analysis. If the
analyzer is operated at an excessive pressure, the sample or balance tube could
become dislodged from its port, possibly causing personal injury or damage to the
equipment.
1. Select Unit [n] > Start Analysis.
2. Click Browse to select a sample information file or accept the next sequenced number.
3. Verify the information populated into the sample identification, density and mass fields. This
information is pulled from the selected file. The density value is applicable only if using the
Calculate method for the free space determination.
4. Click Report after analysis to automatically generate reports when the analysis is complete. On
the Report Settings window, select the report destination. Click OK.
5. Click Start to start the analysis. A window displays data as they are collected. A short delay is
encountered before the port status changes from the Idle state at the bottom of the screen.
239-42828-01 - Dec 2012
Performing an Analysis
3-25