Micromeritics Gemini VII 2390a Operator's Manual page 269

Gemini VII
2448- File directory [path name] is invalid. Resetting to the installation directory.
Cause:
Action:
2449- This field does not contain a valid file specification.
Cause:
Action:
2456- Insufficient file handles available. Application cannot continue.
Cause:
Action:
2458- An instrument is performing a critical operation. Wait a few moments before
exiting the application.
Cause:
Action:
2459- An instrument is busy. A delay in restarting this application could result in loss
of new data. Continue with program Exit? [Yes, No]
Cause:
Action:
239-42828-01 - Nov 2013
A working directory specified in the .INI file is invalid or has been
moved or deleted.
The installation directory will be substituted. The next time a file is
opened, use the Directories list to move to the correct directory.
An invalid file name was entered.
See the description of file naming conventions in a Windows manual
and re-enter the name.
More than 50 files are open at the same time.
Refer to an operating system manual and set the limit for open files to
50 or greater.
An attempt was made to exit the application while the instrument was
performing a critical operation. This operation must be completed
before the application can be stopped.
Wait a short time and attempt to stop the application again.
An attempt was made to exit the application while an analysis was in
progress. While this is possible, the data collected when the
application is inactive will not be permanently recorded until the
application is re-started. A power failure to the instrument could
cause some data to be lost.
If not concerned with the potential for loss of data should a power
failure occur, click Yes to continue; otherwise click No.
Appendix B
B-3