Replacing The Serial Measurement Unit And The Battery Pack - ABB IRB 140 Product Manual

4.6.3 Replacing the serial measurement unit and the battery pack

Location of serial measurement unit and battery pack
The serial measurement unit and battery pack are located inside the manipulator
base as shown in the figure below (different layouts are shown).
DSQC 633A
xx1200000831
A
B
C
Product manual - IRB 140
3HAC027400-001 Revision: V
4.6.3 Replacing the serial measurement unit and the battery pack
Note
The battery low alert (38213 Battery charge low) is displayed when the battery
needs to be replaced. The recommendation to avoid an unsynchronized robot
is to keep the power to the controller turned on until the battery is to be replaced.
For an SMB board with 3-pole battery contact (RMU101 3HAC044168-001 or
RMU102 3HAC043904-001), the lifetime of a new battery is typically 36 months.
For an SMB board with 2-pole battery contact, the typical lifetime of a new battery
is 36 months if the robot is powered off 2 days/week or 18 months if the robot is
powered off 16 h/day. The lifetime can be extended for longer production breaks
with a battery shutdown service routine. See Operating manual - IRC5 with
FlexPendant for instructions.
WARNING
See instructions for batteries,
Battery pack with 2-pole battery contact
Serial measurement board (SMB), DSQC 633A
SMB attachment screws (2 pcs)
© Copyright 2004-2018 ABB. All rights reserved.
Safety risks during handling of batteries on page
4 Repair
35.
Continues on next page
167