Table of Contents
Advertisement
We, Adept Technology, with Corporate Headquarters at 150 Rose Orchard Way, San Jose, CA.,
USA, and European Technical Center at Otto-Hahn-Str. 23, 44227 Dortmund, Germany,
herewith declare that the Robot comprised of:
1. Controller: MV-8 (P/N 30330-15000), MV-19 (P/N 30330-25000)
MV-5 (P/N 30340-10000), or MV 10 (P/N 30340-20000)
2. PA-4 Power Chassis (P/N 30336-31000)
3. B+ Power Amplifiers (P/N 10338-51000)
4. Manual Control Pendant (MCP III) (P/N 90332-48050)
5. VME Front Panel Category 1 (P/N 90332-00380)
6. 550A Mechanism (Model Number 556 for standard, Model Number 557 for
cleanroom) covered under a Declaration of Incorperation
in the form delivered by us to which this Declaration relates, complies with the relevant and fundamental safety and
health requirements defined in the EC Directive 89/336/EEC, Appendix 1, and the following standards:
EN 55011:1991, Class A
EN 50082-2: 1992
EN 292: 1992
EN 60204-1: 1992, IP20
EN 954, Category 1
EN 775; 1992
following the provision of Directives:
89/336/EEC
89/392/EEC
73/23/EEC
under the following usage and environmental conditions:
1. The Robot must not be put into operation until all of the machinery into which it is incorporated
has been declared in compliance with the provisions of the effective versions of the Directives.
This includes all supplementary equipment and protective devices.
2. The system must be used in accordance with instructions specified in Adept Instruction
Handbook for Category 1 Operation per EN 954.
3. The Robot must incorporate only those MV Plug-in Modules listed in Table 1 or Table 2.
If Plug-in Modules listed in Table 2 are installed, the user must verify conformance to the
EMC Directive after installation.
This Declaration is based upon extensive tests and evaluation by TÜV Rheinland, a Notified Body, in their Project
Number E9572254. The complete File is available at the California address.
Place:
San Jose, California, USA
Date:
1 February 1996
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
MANUFACTURER'S DECLARATION
Signed:
Full Name: Richard J. Casler, Jr.
Position: Vice President, Engineering
P/N 01554-00000
Rev. P1
Advertisement
Table of Contents
