Figure 2-5 Installing Mounting Brackets On An Adept Mv Controller - adept technology 550 Instruction Handbook Manual

Installation of the Adept MV Controller and the Adept PA-4 Power Chassis
To Install Mounting Brackets on Adept MV controller:
• Remove (and discard) 3 existing countersunk
screws from side of chassis at locations shown
in drawing.
• Place bracket in desired position and secure
with indicated M4 screws and washers from
accessories kit.
• Repeat process for other side of controller. If the
controller is joined to an Adept PA-4 Power Chassis,
the position of the screws is different on the side
of the controller. See the drawing for the power
chassis.
Note: See Figure 6-8 on page 89 for
dimensions of the controller and
mounting brackets.
M4 x 25mm pan-head screw
(2 places)
M4 x 10mm pan-head screw
Rack Mount – Flush
Figure 2-5. Installing Mounting Brackets on an Adept MV Controller
Adept 550 Robot Instruction Handbook, Rev A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
M4 x 25mm pan-head screw
(2 places)
M4 x 10mm pan-head screw
Panel Mount
M4 x 25mm pan-head screw
(2 places)
M4 x 10mm pan-head screw
Rack Mount – Set-Back
25