Additional Safety Information; Intended Use Of The Robots; Table 1-4 Sources For International Standards And Directives - adept technology 550 Instruction Handbook Manual

Additional Safety Information

The standards and regulations listed in this handbook contain additional guidelines for
robot system installation, safeguarding, maintenance, testing, start-up, and operator
training. The table below lists sources for the various standards.
Table 1-4. Sources for International Standards and Directives
BSI, British Standards Institute
Sales Department
Linford Wood
Milton Keynes
MK14 6LE United Kingdom
Phone 0181 996 7000
Phone 0181 996 7001
Beuth Verlag GmbH
10722 Berlin
Germany
Phone 030 26 01 - 22 60
Fax 030 26 01 - 12 60
IEC, International Electrotechnical Commission
1, Rue de Varembe
1211 Geneva 20, Switzerland
Phone 022 34 01 50
American Electronics Association Europe
40 Rue des Drapiers
1050 Brussels, Belgium
Phone +322/502 7015
Fax +322/502 6734
1.5

Intended Use of the Robots

The installation and usage of Adept products must comply with all safety instructions and
warnings in this manual. Installation and usage must also comply with all applicable
European, international or local requirements and safety standards.
The Adept 550 robot is intended for use in small parts assembly and material handling for
payloads typically less than 5.5 kg (12.1 lb).
WARNING: For safety reasons it is prohibited to make certain types of
modifications to Adept robots, see section 1.6.
!
The Adept MV controller and the Adept PA-4 power chassis are intended for use as
component sub-assemblies of a complete industrial automation system. The controller
and power chassis sub-assemblies must be installed inside a suitable enclosure. The
controller and power chassis sub-assemblies must not come into contact with liquids.
The Adept equipment is not intended for use in any of the following situations:
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Adept 550 Robot Instruction Handbook, Rev A
Intended Use of the Robots
EN 60204, EN 954, EN292, EN 294
IEC 1131, 73, 447
EN 60204, EN 954, EN292, EN 294
IEC 1131, 73, 447
EN 60204, EN 954, EN292, EN 294
IEC 1131, 73, 447
7