Figure 2-6 Installing Mounting Brackets On An Adept Pa-4 Power Chassis - adept technology 550 Instruction Handbook Manual

Chapter 2 - Installation
To Install Mounting Brackets on Adept PA-4
Power Chassis:
• Remove (and discard) 3 existing countersunk
screws from side of chassis at locations shown
in drawing.
• Place bracket in desired position and secure
with indicated M4 pan-head screws and washers from
accessories kit.
• Repeat process for other side of chassis. If the
power chassis is joined to an Adept MV controller,
the position of the screws is different on the side
of the controller. See the controller drawing.
Note: See Figure 6-8 on page 89 for
dimensions of the chassis and
mounting brackets.
M4 x 25mm pan-head screw
(2 places)
M4 x 10mm pan-head screw
Rack Mount – Flush
Figure 2-6. Installing Mounting Brackets on an Adept PA-4 Power Chassis
26
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Adept 550 Robot Instruction Handbook, Rev A
M4 x 25mm pan-head screw
(2 places)
M4 x 10mm pan-head screw
Panel Mount
M4 x 25mm pan-head screw
(2 places)
M4 x 10mm pan-head screw
Rack Mount – Set-Back