Broadcast Key - Christie Mirage HD User Manual

Section 3: Operation
3-44
DMX Channel
Base
Base + 1
Base + 2
Base + 3
Base + 4
Base + 5
Base + 6
Base + 7
Base + 8
Base + 9
* Functions are only active when the Slider Lock is set to Unlocked
NOTE: It is important to ensure the channels DO NOT overlap another device.
Example:
ARTNET DEVICE NAME:
support querying for devices. Press Enter and use the arrow keys to enter a name.
NOTE: Refer to section 3.4 Navigating the Menus, Edit numerical Values, for text
entry description.
ARTNET DEVICE DESCRIPTION:
query" has been done.

Broadcast Key

Enter a checkmark if you want keypad commands sent to one projector to be relayed
to all projectors in a serial network. Note that the
the effect of a broadcast setting and allow you to control a specific projector when
necessary. Disable the setting for all but one (any) projector in a network.
Backlight
Toggle to turn the built-in keypad backlighting on and off.
Front IR / Back IR
As needed for your application, set to "any" so that the front and/or rear IR sensor
locations on the projector respond to the IR keypad. Set to "off" to disable.
To disable both IR sensors, you cannot use the IR remote keypad to select the second
setting. This safeguard prevents accidentally disabling an IR keypad while you
OFF
Function
Shutter
Slider Lock
Input *
Channel *
Lens – Vertical * †
Lens – Horizontal * †
Lens – Focus * †
Lens – Zoom * †
Power *
None
Good
Proj1_Base = 0 Proj1_Base = 5
Proj2_Base = 10 Proj2_Base = 9
Proj3_Base = 20 Proj3_Base = 11
This option is used to name each device; some ArtNet servers
More information that is returned when a "device
Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
Value
0 – 64 Open
65 – 192 No Action
193 – 255 Closed
0 – 254 Locked
255 Unlocked *
1 – 8 Input #
1-99 Channel #
0 Lens Down
1 – 254 Stop
255 Lens Up
0 Lens Right
1 – 254 Stop
255 Lens Left
0 Negative Focus
1 – 254 Stop
255 Positive Focus
0 Zoom Out
1 – 254 Stop
255 Zoom In
0 Power Off
1 – 254 No Action
255 Power On
Bad
key will temporarily "override"
Proj
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher