Broadcast Key - Christie roadie 25k User Manual

PORT:
On some Ethernet networks, firewall restrictions may require that the port
number of the projector be changed from its default of 3002. If so, enter a new valid
port number here.

Broadcast Key

Enter a checkmark if you want keypad commands sent to one projector to be relayed
to all projectors in a serial network. Note that the
"override" the effect of a broadcast setting and allow you to control a specific
projector when necessary. Make sure to remove the Broadcast Key checkmark when
operating redundant networks.
Backlight
Toggle the built-in keypad lighting on/off.
Front IR / Back IR
NOTE: With v1.0 software, only one IR keypad protocol (A) is recognized at each of
the projector's IR sensors. Response can be toggled on or off independently in the
menu as desired for your application. Use of multiple protocols as described here
requires a software upgrade.
As described in Section 2, the standard IR remote keypad is capable of sending data
to the projector in either one of seven different protocols called
its internal jumper settings (default=
the projector can be set to accept IR data accordingly, responding to one of the
,
protocols all or none. The projector's
projector installations. Select a specific protocol to work with only certain projectors
in a multi-projector group.
Note that the front and rear IR sensors cannot respond to different protocols–
changing a protocol for either sensor to anything other than
for the other sensor too. For example, setting Front IR to
E
to . If you want only one sensor to respond to a particular protocol, you must disable
the other sensor by setting its protocol to
To disable both IR sensors, you cannot use the IR remote keypad to select the second
OFF
setting. This safeguard prevents accidentally disabling a keypad while you are
using it. Instead, use either the built-in keypad or the wired remote (optional) to set
the remaining active sensor to
remote keypad.
NOTES: The IR remote keypad for this projector is set at manufacture to "Protocol
A". See 2.14, Remote Keypad Protocols and Conversion for information about
changing the keypad protocol for use with supporting software.
Wired Keypad
Select "On" to enable use of a wired remote keypad connected to either the rear of
the projector (standard keypad with XLR connector) or the side input panel (optional
keypad with phono-jack connector). The projector will then respond to incoming
commands from either port. To disable the wired keypad, you must use a different
keypad—the built-in or an IR remote keypad—to select "off". This safeguard
prevents you from accidentally disabling the wired keypad during use.
Proj
A
). Likewise, the front and rear IR sensors on
"All"
default is adequate for most single-
OFF
.
OFF
. The projector will no longer respond to an IR
OPERATION
key will temporarily
A – G
, depending on
OFF
changes the protocol
E
also changes the Back IR
Roadie 25K User's Manual
A – G
3-41