Installing The Battery To Gt2506Hs-V - Mitsubishi Electric GOT2000 Series Hardware User Manual

5.
After installing the battery to the battery holder of the GOT, close the battery cover until it clicks.
Battery cover
Battery Connector
6.
Turn on the GOT.
7.
Check that the battery condition is normal with the utility.
For the details of the battery condition display, refer to the following.
GOT2000 Series User's Manual (Utility)

Installing the battery to GT2506HS-V

The following shows the battery installation procedure.
1.
Make sure that the GOT power is off.
2.
Loosen the environmental protection back cover screws at two points on GOT rear face to remove the cover.
3.
Insert the battery connector to the connector for battery connection on the GOT, and put the battery into place.
Insert the red lead as to pass it through the notch on the circuit board.
Lead (Black)
Insertion
direction
Battery
Circuit
Lead (Red)
board
Environmental
protection
back cover
screw
Connector for
battery connection
Battery
Notch
6 INSTALLATION AND REMOVAL
6.10 Installing the Battery
6
231