Mitsubishi Electric GOT2000 Series Hardware User Manual page 206

5.
Mark the four corners of the stencil on the control panel with a pencil or others.
Remove the stencil.
Stencil
6.
Remove the protective film from the GOT, and make sure that no dust or other substances adhere to the display section.
7.
Peel off a part of the release paper on the back of the environmental protection sheet.
Do not touch the adhesive part of the sheet where the release paper is peeled off. Align the sheet with the four markings on
the control panel, and attach the peeled off part of the sheet to the control panel.
A part of the
release paper
Environmental
protection sheet
6 INSTALLATION AND REMOVAL
204
6.6 Installing the GOT
panel
Peeling off
Marking
panel
Release paper
Marking