Mitsubishi Electric GOT2000 Series Hardware User Manual page 278

Connector conversion adapter installation
Installing the connector conversion adapter and the flange is required to connect the RS-485 unfastened cable with the
connector conversion adapter.
■Installation of the connector conversion adapter GT10-9PT5S (sold separately) and the flange
(packed together with the connector conversion box)
Install to the adapter and the flange with two screws which are packed together with the connector conversion adapter.
Tighten the screws within the specified torque range (0.3 N•m to 0.6 N•m).
Tightening screws too much may cause damage on the connector conversion adapter.
■Installation to the connector conversion box
Mount the connector conversion adapter to the RS-422/485 connector of the connector conversion box and fix them with two
screws which are packed together with the connector conversion box.
Tighten the screws within the specified torque range (0.3 N•m to 0.6 N•m).
Tightening screws too much may cause damage on the connector conversion box and the flange.
7 OPTION AND COMMUNICATION CABLE FOR HANDY GOT
276
7.1 Connector Conversion Box
Connection Conversion Adapter
Flange