Mitsubishi Electric GOT2000 Series Hardware User Manual page 207

8.
Peel off the remainder of the release paper, and attach the whole environmental protection sheet to the control panel.
Make sure to attach the sheet from the attached part in step 7, and fit the sheet onto the control panel without leaving any air
between them.
Environmental
protection sheet
9.
Erase the markings.
10.
Apply enough pressure to the adhesive part of the environmental protection sheet.
(Roll a roller back and forth two times with a load of 2 kg.)
To ensure adequate adhesive strength, you are recommended to use the GOT about 24 hours later after the environmental
protection sheet is attached.
Check that the environmental protection sheet has no wrinkle, dirt, or others, and then remove the protective film from the
sheet.
Remainder of the
release paper
Marking
protection sheet
Environmental
protection sheet
6 INSTALLATION AND REMOVAL
6.6 Installing the GOT
6
205