Installation Position; Gt27 - Mitsubishi Electric GOT2000 Series Hardware User Manual

6.4

Installation Position

To install the GOT, some distance is required between the GOT and the other devices.

GT27

Depending on the units and cables used for the GOT, the distance more than the described dimensions may be required.
Install the GOT with consideration of the connector dimensions and the cable bend radius.
For the cable pull-out distance from the bottom of the GOT, refer to the following.
Page 410 Cable Bend Radius for GT27 with an Extension Unit
For the vertical installation, install the GOT so that the vertical installation arrow printed on the GOT rear face points upward.
Page 117 GT27
C
6 INSTALLATION AND REMOVAL
178
6.4 Installation Position
B
D
A
Horizontal
D
A
C
Vertical
E
Panel thickness: 1.6 mm to 4 mm
(0.06 to 0.16inch)
E
Panel thickness: 1.6 mm to 4 mm
(0.06 to 0.16inch)