Mitsubishi Electric GOT2000 Series Hardware User Manual page 209
Graphic operation terminal
Hide thumbs
Also See for GOT2000 Series:
- Connection manual (1224 pages) ,
- User manual (654 pages) ,
- Basic training textbook (255 pages)
Table of Contents
Advertisement
Cautions for the GOT installation
• Tightening torque of the mounting screws
Tighten mounting screws within the specified torque range.
Undertightening can cause the GOT to drop.
In addition, waterproof effect or oilproof effect may not be obtained.
Tightening the screw in the specified torque range or more may damage the GOT or distort the panel, causing
wrinkles on the surface of the display section. The wrinkles may lower visibility and lead to an incorrect input
to the touch panel.
Waterproof effect or oilproof effect may not be obtained because of distortion of the GOT or panel.
• Tightening method for mounting screws
When tightening the mounting screws, tighten each of the four screws gradually and evenly. Tightening a
fitting with excessive concentration of force may damage the GOT or distort the panel.
Tighten the mounting screws at right angles to the surface of the panel. (See Figure 1 below.)
If mounting screws are not at right angles to the surface of the panel, excessive force will be applied and may
damage the GOT. (See Figure 2 below.)
1. Good example
4.
The GOT in the factory shipment state has a protective film on the display section.
After installing the GOT, remove the film.
2. Bad example
6 INSTALLATION AND REMOVAL
207
6.6 Installing the GOT
6
Advertisement
Table of Contents
Troubleshooting
