Installing The Battery To Gt2310 Or Gt2308 - Mitsubishi Electric GOT2000 Series Hardware User Manual

4.
Install the battery to the GOT.
5.
Attach the environmental protection back cover and tighten the screws within the specified torque range (0.36 N•m to
0.48 N•m).
6.
Turn on the GOT.
7.
Check that the battery condition is normal with the utility.
For the details of the battery condition display, refer to the following.
 GOT2000 Series User's Manual (Utility)

Installing the battery to GT2310 or GT2308

The following shows the battery installation procedure, taking GT2310 as an example.
1.
Make sure that the GOT power is off.
2.
Install the battery to the GOT rear face.
Open the battery cover as shown below.
Battery cover
3.
To replace the battery, remove the old battery, and then disconnect the connector.
For information on how to remove the battery, refer to the following.
Page 237 Removing the Battery
Insertion direction
Battery
Lead (Red)
Lead (Black)
Circuit board
Battery
Connector for
battery connection
6 INSTALLATION AND REMOVAL
6.10 Installing the Battery
6
233