Mitsubishi Electric GOT2000 Series Hardware User Manual page 138

Part names and settings of GT25HS-V
No. Name
1) Display section
2) Touch panel
3) Operation switch (6 switches)
4) Operation switch name sheet
installation place
5) Emergency stop switch
6) POWER LED
7) Display LED for operation switch (6
LEDs)
8) Display LED for grip switch
9) External interface connector
10) Environmental protection back cover
11) Environmental protection back cover
screw
12) Hook for hanging on walls
13) Hand strap
14) Grip angle changing screw
15) Grip switch
16) Rating plate
17) Battery (inside the cover)
18) Connector for battery connection (inside
the cover)
19) RS-232 connector
20) RS-422/485 connector
21) RS-422 connector
22) Ethernet connector
23) Cable connector for PLC
communication
4 PART NAMES AND SETTINGS
136
4.5 GT25HS-V
Description
Displays the utility and the user-created screen.
For operating the touch switches in the utility and the user-created screen
Switch for external direct wiring (independent contact)
Place (concave shape) where the operation switch name sheet (Insert into the space from a transverse
direction) is installed.
For the details, refer to the following.
Page 347 Operation switch name sheet creation (GT2506HS-V)
Switch for external direct wiring (independent contact)
Lit in blue: Power is properly supplied.
Lit in orange: Screen saving
Blinks in orange and blue: Backlight failure
Not lit: Power is not supplied.
Display LED for operation switch (green) (lighting control from display section)
Display LED for grip switch (green) (lighting control from display section)
• GT2506HS-V
For external cable connection (for PLC, switch and power supply external wiring) (Connector shape:
square 42 pins, male)
• GT2505HS-V
For connecting an external cable to a PLC, switch, or power supply (Connector shape: Round 37 pins,
male)
• GT2506HS-V
Opened and closed when the PLC communication type is changed (RS-422/485 RS-232,before
shipping: RS-422/485), or the battery is replaced.
• GT2505HS-V
Opened and closed when the PLC communication type is changed among Ethernet, RS-422, and RS-
232 (factory default: Ethernet), or when the battery is replaced.
For opening and closing the environmental protection back cover (drop prevention screw)
Hook when the Handy GOT is used hanging on walls.
Used to hold the Handy GOT in hand by putting a hand under the strap.
Length adjustable.
Used when changing the angle of the grip. (5, M4 screw)
The angle of the grip can be set either to the standard angle (as before shipping) or 15 degrees to the
right.
Switch for external direct wiring (independent contact)
—
For backing up clock data, system log data, and buffering data
For battery connection
Connector for PLC communication using RS-232
For the pin layout of the connector, refer to the following.
GOT2000 Series Handy GOT Connection Manual For GT Works3 Version1
Connector for PLC communication using RS-422/485
For the pin layout of the connector, refer to the following.
GOT2000 Series Handy GOT Connection Manual For GT Works3 Version1
For communicating with a PLC using RS-422
For the pin layout of the connector, refer to the following.
GOT2000 Series Handy GOT Connection Manual For GT Works3 Version1
For communicating with a PLC using Ethernet
Interface cable connector for PLC communication
• GT2506HS-V
Connector for either 19) or 20) and for selection of the PLC communication type.
(Connected to RS-422/485 before shipping.)
• GT2505HS-V
Connect this connector to one of the above connectors (19), 21), or 22)), and select a PLC
communication type.
(Connected to the Ethernet connector at factory default.)