Mitsubishi Electric GOT2000 Series Hardware User Manual page 14

[PRECAUTIONS FOR USE]
CAUTION
● When you operate the Handy GOT while holding it, slide your hand through the hand strap on the
back of the GOT to prevent falling.
The hand strap length is adjustable.
● When you remove a cable from the Handy GOT, do not pull the cable portion.
Doing so may damage the unit or cable, or cause a malfunction due to a cable connection fault.
● Do not drop or strike the Handy GOT.
Doing so may damage the GOT.
● When you carry or operate the Handy GOT, hold its body.
Carrying or operating the Handy GOT while holding its cable may damage the unit or cable.
● Determine whether to use the emergency stop switch of the Handy GOT according to your risk
assessment.
● If you use a parallel circuit (to avoid entering the emergency stop status while the Handy GOT is
removed), the system may not conform to the safety standards.
Check the safety standards required for your system before use.
● If the Handy GOT is exposed to any impact beyond the general specifications, chattering may occur in
the emergency stop switch for its structural reasons.
Check that your use conditions are proper.
● Do not touch the edges of the touch panel (display section) repeatedly.
Doing so may result in a failure.
● Do not turn off the GOT while data is being written to the storage memory (ROM) or SD card.
Doing so may corrupt the data, rendering the GOT inoperative.
● The GOT rugged model uses the environmental protection sheet (not replaceable) with UV protection
function on the front surface.
Therefore, it is possible to suppress deterioration of the touch panel or the liquid crystal display panel
that may be caused by ultraviolet rays.
Note that if the rugged model is exposed to ultraviolet rays for an extended period of time, the front
surface may turn yellow.
If the rugged model is likely to be exposed to ultraviolet rays for an extended period of time, it is
recommended to use a UV protective sheet (option).
12