GT2505-V
For the vertical installation, check that the vertical installation arrow mark on the GOT rear face points upward.
1.
Install a packing to the packing installation groove on the GOT rear face.
Fit the thin side of the packing in the packing installation groove.
Packing
Enlarged view
2.
Insert the GOT rear face into the panel opening.
3.
Fix the GOT.
Insert the hook of an installation fitting (supplied) into the mounting hole of the GOT.
Tighten the supplied screws within the specified torque range (0.36 N•m to 0.48 N•m) to fix the GOT
Fix the GOT using 4 fittings at the top and the bottom of the GOT.
6 INSTALLATION AND REMOVAL
206
6.6 Installing the GOT
Packing
Packing
installation groove
Panel opening
Enlarged view
Installation
fitting
Mounting screw