Mitsubishi Electric GOT2000 Series Hardware User Manual page 125

Part names and settings of GT2510-WX and GT2507-W
No. Name
1) Display section
2) Touch panel
3) USB interface (Device/front)
4) POWER LED
5) Unit installation fitting
6) Reset switch
7) S.MODE switch
8) SD card access LED
9) SD card interface (inside the cover)
10) SD card cover
11) Battery (inside the cover)
12) Terminating resistor setting switch (inside the
cover)
13) Wireless LAN communication unit interface
(inside the cover)
14) USB interface (Host/back)
15) Cable clamp mounting hole
16) Vertical installation arrow mark
17) Power terminal
18) Ethernet interface (port 1)
19) Ethernet interface (port 2)
20) Ethernet communication status LED
21) RS-422/485 interface
22) RS-232 interface
23) Sound output interface
24) Rating plate
Description
Displays the utility and the user-created screen.
For operating the touch switches in the utility and the user-created screen
For connecting a personal computer (Connector shape: Mini-B)
Lit in blue: Power is properly supplied.
Lit in orange: Screen saving
Blinks in orange and blue: Backlight failure
Not lit: Power is not supplied.
Mounting fixtures for fixing the GOT to the control panel
Hardware reset switch
Used for OS installation at the GOT startup
ON: SD card installed
Blink: SD card accessed
OFF: SD card not installed or SD card installed but removal possible
For installing an SD card
Has the function to switch the access to the SD card between enabled and disabled states.
When the cover is opened: Access prohibited
When the cover is closed: Access allowed
Space for housing the battery
Switches the terminating resistor for the RS-422/485 communication port between used and unused
states (initial setting (unused))
For installing a wireless LAN communication unit
For connecting a USB mouse, a USB keyboard, or a USB barcode reader, and transferring or saving
data (Connector shape: TYPE-A)
For attaching a cable clamp to prevent the USB cable or the sound output cable from being
accidentally pulled out
For the vertical installation, install the GOT so that the arrow points upward.
Power input terminal, FG terminal
For communicating with a controller or connecting a personal computer (connector shape: RJ-45
(modular jack))
SD/RD LED ON: Data sent or received
SD/RD LED OFF: Data not sent or received
SPEED LED ON: Communicating at 100 Mbps
SPEED LED OFF: Communicating at 10 Mbps or disconnected
For communication with a controller (Connector shape: D-sub 9-pin (female))
For the pin layout of the connector, refer to the following.
GOT2000 Series Connection Manual (Mitsubishi Electric Products) For GT Works3 Version1
For communication with a controller (Connector shape: D-sub 9-pin (male))
For the pin layout of the connector, refer to the following.
GOT2000 Series Connection Manual (Mitsubishi Electric Products) For GT Works3 Version1
For outputting sounds (applicable plug: Φ3.5 stereo mini-plug (3-prong))
—
4 PART NAMES AND SETTINGS
4.2 GT2510-WX, GT2507-W
4
123