Stud; Stud Specifications; Distance Between Studs - Mitsubishi Electric GOT2000 Series Hardware User Manual

6.3

Stud

Stud specifications

Use the studs that satisfy the following specifications.
Diameter
M4
The studs on the control panel must have strength adequate to withstand a tightening torque of 0.9 N•m or more.
Make sure that no foreign matter such as welding waste is at and around the bases of the studs.
Tighten nuts on the studs in the specified torque range (0.8 N•m to 0.9 N•m) with a wrench for M4 nuts.

Distance between studs

GT2512F-S, GT2510F-V, GT2508F-V
To mount the GOT on the control panel, studs are necessary.
Align the studs with the installation holes of the fittings, and install the studs.
The fittings must be installed on the top and bottom, or the right and left of the GOT.
For GT2512F, you are recommended to install the fittings on the long sides of the GOT.
■Measurements based on the screen center
Horizontal
Y1
Back of the control panel
Unit: mm (inch)
Model X
GT2512F-S 214(8.43)
(+2(0.08), 0(0))
GT2510F-V 187(7.36)
(+2(0.08), 0(0))
GT2508F-V 158(6.22)
(+2(0.08), 0(0))
Length
10 mm (0.39 inch) or more
Y
Y2
Screen center
panel opening
X1 X2
103(4.06) (111(4.37))
(+2(0.08), 0(0))
89.5(3.52) (97.5(3.84))
(+1(0.04), 0(0))
75.25(2.96) (82.75(3.26))
(+1(0.04), 0(0))
X
X1
Vertical
Back of the control panel
Y Y1
269(10.59) 134.5(5.30)
(+2(0.08), 0(0)) (+1(0.04), 0(0))
234(9.21) 117(4.61)
(+2(0.08), 0(0)) (+1(0.04), 0(0))
194(7.64) 97.5(3.84)
(+2(0.08), 0(0)) (+1(0.04), 0(0))
6 INSTALLATION AND REMOVAL
X2
Screen center Screen center Screen center
Y2
(134.5(5.30))
(117(4.61))
(96.5(3.80))
6.3 Stud
6
175