Mitsubishi Electric GOT2000 Series Hardware User Manual page 203

For GT27 except GT2715-X, GT25, and GT23 (4 fittings)
3.
Remove the protective film from the GOT.
GT2512F-S, GT2510F-V, GT2508F-V
To fasten the fittings on the control panel, studs are neccessary.
For the details of panel cutting dimensions and studs, refer to the following.
Page 168 Panel Cut Dimensions
Page 175 Stud
The following table shows the material and surface treatment of the control panel recommended for attaching the
environmental protection sheet..
Item
Material
Surface roughness
*1 When you coat the environmental protection sheet, use melamine resins or acrylic resins.
*2 The environmental protection sheet must be coated with melamine resins or acrylic resins.
Check that no dirt or damage is on the control panel on which the environmental protection sheet is attached.
Since the environmental protection sheet cannot be reattached, make sure to check the attachment method and attach the
sheet carefully.
After removing the protective film from the GOT, make sure that no dust or other substances adhere to the display section.
Check that the GT25 open frame model is installed properly, and then remove the protective film from the GOT.
Do not conduct this work in a dusty place, or foreign substances may adhere to the display section.
The following shows the procedure for installing GT2512F-S as an example. In this example, the supplied fittings are installed
on the top and bottom of the GOT, and the control panel thickness is 3 mm.
Description
*1 *1 *2
Stainless or aluminum or steel
Ra0.2 to 0.5 (μm)
6 INSTALLATION AND REMOVAL
201
6.6 Installing the GOT
6