Mitsubishi Electric GOT2000 Series Hardware User Manual page 141

Part names and settings of GT23
No. Name
1) Display section
2) Touch panel
3) POWER LED
4) Unit installation fitting
5) S.MODE switch
6) SD card access LED
7) SD card interface (inside the cover)
8) SD card cover
9) USB interface (Host)
10) USB interface (Device)
11) Cable clamp mounting hole
12) Terminating resistor setting switch (inside the
cover)
13) Battery (inside the cover)
14) Vertical installation arrow mark
15) Power terminal
16) Ethernet interface
17) Ethernet communication status LED
18) RS-232 interface
19) RS-422/485 interface
20) Rating plate
Description
Displays the utility and the user-created screen.
For operating the touch switches in the utility and the user-created screen
Lit in blue: Power is properly supplied.
Lit in orange: Screen saving
Blinks in orange and blue: Backlight failure
Not lit: Power is not supplied.
Mounting fixtures for fixing the GOT to the control panel
Used for OS installation at the GOT startup
ON: SD card installed
Blink: SD card accessed
OFF: SD card not installed or SD card installed but removal possible
For installing an SD card
Has the function to switch the access to the SD card between enabled and disabled states.
When the cover is opened: Access prohibited
When the cover is closed: Access allowed
For connecting a USB mouse, a USB keyboard, or a USB barcode reader, and transferring or
saving data (Connector shape: TYPE-A)
For connecting a personal computer (Connector shape: Mini-B)
Cable clamp mounting hole as a precaution against a disconnection of the USB cable
Switches the terminating resistor for the RS-422/485 communication port between used and
unused states (initial setting (unused))
Space for housing the battery
For the vertical installation, install the GOT so that the arrow points upward.
Power input terminal, LG terminal, FG terminal
For communicating with a controller or connecting a personal computer (Connector shape: RJ-45
(modular jack))
SD/RD LED ON: Data sent or received
SD/RD LED OFF: Data not sent or received
SPEED LED ON: Communicating at 100 Mbps
SPEED LED OFF: Communicating at 10 Mbps or disconnected
For communication with a controller (Connector shape: D-sub 9-pin (male))
For the pin layout of the connector, refer to the following.
GOT2000 Series Connection Manual (Mitsubishi Electric Products) For GT Works3 Version1
For communication with a controller (Connector shape: D-sub 9-pin (female))
For the pin layout of the connector, refer to the following.
GOT2000 Series Connection Manual (Mitsubishi Electric Products) For GT Works3 Version1
—
4 PART NAMES AND SETTINGS
4.6 GT23
4
139