Table of Contents
Advertisement
5-12
The multifunction encoder knob is used to select, modify and
confirm all the functions shown on display.
The encoder knob is used to access the MENU function and then
to function modes, parameters, alarms, parameters' values and
all is concerned to the normal operation of ventilator
Use of encoder knob.
•
Press the encoder to access the modification (habilitation) of
the parameter (function); rotate clockwise or counter-
clockwise to select the box;
•
Rotate clockwise (counter-clockwise) to increase (decrease);
press the knob to confirm.
If the encoder knob is not pressed within 10
seconds to confirm a value after modifying it, the
ventilator will restore the value prior to the
modification.
By pressing MAN soft key it is possible to start ventilation in the
manual mode.
The functional switch ON or OFF of ventilator is possible by the
ON/OFF key. To switch on the ventilator press the ON/OFF key.
After a few seconds a series of messages appears on the
screen, indicating that the system is entered in the SELF TEST
phase; this phase takes some minutes.
At the end of this procedure the equipment is ready to ventilate
the patient. Keep pressed the ON/OFF soft key for a few seconds
to switch off the ventilator (this function has been introduced to
avoid accidental shutdowns of the same).
When the led is light on (green colour) it indicates that the
ventilator is supplied by the main power supply.
When the led is light on ( orange colour) it indicates that the
ventilator is supplied by the auxiliary battery.
User's Manual, version DU3300105
Advertisement
Table of Contents
