Initialization phase
Keys and encoder
knob
Error in the bus
"CAN"
Patient circuit
disconnected
9-2
The initialization phase is not completed and the system is
blocked.
•
Verify and intervene in function on the error messages and
indications evidenced during the "SELF TEST" phase.
•
Turn off and on the anaesthesia unit and repeat "SELF TEST"
phase.
•
Contact the Siare Service Centre or a Centre authorised by Siare.
The keys or the encoder knob do not work
•
Switch the anaesthesia unit OFF and then switch back ON.
•
Contact the Siare Service Centre or a Centre authorised by Siare.
This alarm condition occurs in case of system failure (electronic
boards).
•
Contact the Siare Service Centre or a Centre authorised by Siare
This alarm conditions occurs in case of pneumatic circuit
malfunctioning.
•
Check that the alarm limits are set correctly.
•
Check that the mask, endotracheal tube and patient circuit are not
in some way split, disconnected or connected wrongly If this is the
case, eliminate the problem or replace them.
•
Check the correct settings of the patient's respiratory parameters
(according to the operative mode selected: Volume/Flow, Rate,
I/E, Trigger).
•
Check that the patient circuit is connected correctly to the
anaesthesia unit and to the patient.
•
If this is not the case, contact the Siare Service Centre or a Centre
authorised by Siare.
User's Manual, version DU3300105