Editing Text Parameters Using The Traditional Method; Figure 3-10 The Character Cycle Of The Traditional Text Edit Method - Olympus 45MG User Manual

8. To complete editing of the parameter value, highlight DONE on the virtual
keyboard, and then press [ENTER].
NOTE
When editing a multiple line parameter value, highlight DONE and press [ENTER] to
move the cursor to the next line. You can also press [2nd F], [] to accept the text and
move the cursor to the next line.
3.4.2

Editing Text Parameters Using the Traditional Method

When the TEXT EDIT MODE is set to TRADITIONAL, select each character from a
hidden circular list of standard sorted letters, numbers, and special characters (see
Figure 3-10 on page 41). Only uppercase letters are available.

Figure 3-10 The character cycle of the traditional text edit method

To edit an alphanumeric parameter value using the traditional method
1. Select an alphanumeric parameter.
[]
Cycling begins at "A" when the
original character is a letter.
Cycling begins at "0" when the
original character is a digit.
[]
Software User Interface Elements
DMTA-10022-01EN, Rev. C, January 2015
41