Setting Vipa Specific Cpu Parameters - YASKAWA CPU 013C Manual

Deployment CPU 013-CCF0R00

Setting VIPA specific CPU parameters

General
Address
4.8 Setting VIPA specific CPU parameters
Overview
70
n Short description
– Here the short description "MPI/DP" for the interface is specified.
n Name
– At Name "MPI/DP" is shown. If you change the name, the new name appears in
the Siemens SIMATIC Manager.
n Type
– Here you can choose between the functionalities MPI and PROFIBUS.
n Interface
– Here the MPI respectively PROFIBUS address is shown.
n Properties
– With this button the properties of the interface may be pre-set.
n Comment
– You can enter the purpose of the interface.
n Diagnostics
– A diagnostics address for the interface is to be pre-set here. In the case of an
error the CPU is informed via this address.
n Operating mode
– With the interface type 'PROFIBUS' here you can pre-set the 'Operating mode'
DP Slave.
Configuration, Clock
n
– These parameters are not supported.
Except of the VIPA specific CPU parameters the CPU parametrization takes place in the
parameter dialog of the CPU 314C-2 PN/DP (314-6EH04-0AB0 V3.3) from Siemens.
After the hardware configuration of the CPU you can set the parameters of the CPU in
the virtual IO device 'VIPA SLIO CPU' . Via double-click at the VIPA SLIO CPU the prop-
erties dialog is opened
Here the following parameters may be accessed:
n Function X3
n Additional retentive memory
n Additional retentive timer
n Additional retentive counter
n Diagnostics interrupt 5L+ (DC 24V DI power section supply)
Diagnostics interrupt 2L+ (DC 24V DO power section supply)
n
Diagnostics interrupt DO short circuit / overload
n
n Diagnostics interrupt sensor short circuit / overload
n Diagnostics interrupt 3L+ (DC 24V SLIO bus power section supply)
VIPA System SLIO
HB300 | CPU | 013-CCF0R00 | en | 16-40