Table of Contents
Advertisement
Deployment CPU 013-CCF0R00
Reset to factory settings
4.14
Reset to factory settings
Proceeding
82
5.
The update is successful finished when the LEDs PW, ST, SF, FC and SD are on. If
they are blinking fast, an error occurred.
6.
Turn power OFF and ON. Now it is checked by the CPU, whether further firmware
updates are to be executed. If so, again the LEDs SF and FC flash after a short
start-up period. Continue with 3. If the LEDs do not flash, the firmware update is fin-
ished.
7.
Now a Reset to factory setting as described next should be executed. After that the
CPU is ready for duty.
With the following proceeding the internal RAM of the CPU is completely deleted and the
CPU is reset to delivery state.
Please regard that the MPI address is also reset to default 2 and the IP address of the
Ethernet PG/OP channel is reset to 0.0.0.0!
A factory reset may also be executed by the command FACTORY_RESET.
4.17 'CMD - auto commands' on page 86
1.
Switch the CPU to STOP.
2.
Push the operating mode switch down to position MR for 30 seconds. Here the
STOP-LED flashes. After a few seconds the STOP LED changes to static light. Now
the STOP LED changes between static light and flashing. Start here to count the
static light of the STOP LED.
3.
After the 6. static light release the operating mode switch and tip it downwards to
MR. Now the RUN LED lights up once. This means that the RAM was deleted com-
pletely.
4.
For the confirmation of the resetting procedure the LEDs PW, ST, SF, FC and MC
get on. If not, the factory reset has failed and only an overall reset was executed. In
this case you can repeat the procedure. A factory reset can only be executed if the
STOP LED has static light for exact 6 times.
5.
The end of factory reset is shown by static light of the LEDs PW, ST, SF, FC and
SD. Switch the power supply off and on.
The following figure illustrates the procedure above:
Ä Chapter 4.14 'Reset to factory settings' on page 82
HB300 | CPU | 013-CCF0R00 | en | 16-40
VIPA System SLIO
Ä Chapter
Advertisement
Table of Contents
