YASKAWA CPU 013C Manual page 134

Deployment I/O periphery
Frequency measurement > Parametrization
Sub module Output address
Counter 816
820
824
828
5.7.5.2 Interrupt selection
5.7.5.3 Operating mode per channel
Parameter hardware con-
figuration
134
Access
DWORD
DWORD
DWORD
DWORD
Via 'Basic parameters' you can reach 'Select interrupt' . Here you can define the inter-
rupts the CPU will trigger. The following parameters are supported:
n None: The interrupt function is de-activated.
n Process: The following events of the frequency measurement can trigger a hardware
interrupt (selectable via 'Frequency counting' ):
– End of measurement
n Diagnostics and process: A diagnostics interrupt is only triggered when a hardware
interrupt was lost.
Select via 'Channel' the channel select via 'Operating' the operating mode. The fol-
lowing operating modes are supported:
n Not parameterized: Channel is deactivated
n Ä Chapter 5.6.6.1 'Count continuously' on page 115
n Ä Chapter 5.6.6.2 'Count once' on page 116
Ä Chapter 5.6.6.3 'Count Periodically' on page 119
n
Ä Chapter 5.7 'Frequency measurement' on page 128
n
Ä Chapter 5.8 'Pulse width modulation - PWM' on page 137
n
Depending on the selected operating mode default values are loaded and shown in an
additional register.
Assignment
reserved
reserved
reserved
reserved
HB300 | CPU | 013-CCF0R00 | en | 16-40
VIPA System SLIO