Table of Contents
Advertisement
VIPA System SLIO
2.9 General data
Conformity and approval
Conformity
CE
Approval
UL
others
RoHS
Protection of persons and device protection
Type of protection
Electrical isolation
to the field bus
to the process level
Insulation resistance
Insulation voltage to reference earth
Inputs / outputs
Protective measures
Environmental conditions to EN 61131-2
Climatic
Storage / transport
Operation
Horizontal installation hanging
HB300 | CPU | 013-CCF0R00 | en | 16-40
n
At stationary operation it is convenient to strip the insulated cable interruption free
and lay it on the isolation/protected earth conductor line.
n
To fix the isolation tangles use cable clamps out of metal. The clamps must clasp the
isolation extensively and have well contact.
n
Lay the isolation on an isolation rail directly after the entry of the cable in the cabinet.
Lead the isolation further on to your PLC and don't lay it on there again!
CAUTION!
Please regard at installation!
At potential differences between the grounding points, there may be a
compensation current via the isolation connected at both sides.
Remedy: Potential compensation line
2014/35/EU
2014/30/EU
-
2011/65/EU
-
-
-
-
-
-
EN 60068-2-14
EN 61131-2
Low-voltage directive
EMC directive
Refer to Technical data
Restriction of the use of certain hazardous substances in
electrical and electronic equipment
IP20
electrically isolated
electrically isolated
-
AC / DC 50V, test voltage AC 500V
against short circuit
-25...+70°C
0...+60°C
Basics and mounting
General data
35
Advertisement
Table of Contents
