Status Indication; Diagnostic And Interrupt; Overview - YASKAWA CPU 013C Manual

VIPA System SLIO

5.8.6 Status indication

Digital output
DO +0.0 ... DO +0.7
DO +1.0 ... DO +1.3
Power supply
1L+
2L+
3L+
5L+
Error
1F
2F
on: ● | off: ○

5.9 Diagnostic and interrupt

5.9.1 Overview

Hardware interrupt
HB300 | CPU | 013-CCF0R00 | en | 16-40
LED Description
green
● Digital output Q+0.0 ... 0.7 has "1" signal
○ Digital output Q+0.0 ... 0.7 has "0" signal
● Digital output Q+1.0 ... 1.3 has "1" signal
○ Digital output Q+1.0 ... 1.3 has "0" signal
LED Description
green
● DC 24V electronic section supply
○ DC 24V electronic section supply not available
● DC 24V power section supply outputs OK
○ DC 24V power section supply outputs OK
● DC 24V power section supply SLIO bus OK
○ DC 24V power section supply SLIO bus not available
● DC 24V power section supply inputs OK
○ DC 24V power section supply inputs not available
LED Description
red
● Error power supply sensor
○ no error
● Error at overload respectively short circuit at the outputs
○ no error
The parametrization allows you to define the following trigger for a hardware interrupt:
n Edge at an digital interrupt input
n Reaching the comparison value
n Overflow respectively at overrun upper counter limit
Underflow respectively at underrun lower counter limit
n
n Opening the HW gate with open SW gate - except for counter 3
n Closing the HW gate with open SW gate - except for counter 3
Deployment I/O periphery
Diagnostic and interrupt > Overview
145