Operating Mode Switch; Leds - YASKAWA CPU 013C Manual

VIPA System SLIO

3.2.6 Operating mode switch

General

3.2.7 LEDs

CPU part
PW Meaning
green ● As soon as the CPU is supplied with 5V, the green PW-LED (Power) is on.
○ The CPU is not power-supplied.
on: ● | off: ○
RN ST
green yellow
Boot-up after PowerON
● X
● ●
● ●
● ●
○ ●
Operation
○ ●
BB ●
○ BB
HB300 | CPU | 013-CCF0R00 | en | 16-40
CAUTION!
Please connect the CPU for approximately 1 hour to the power supply, so
that the internal buffering mechanism is loaded accordingly.
In case of failure of the buffer mechanism Date and Time 01.09.2009
00:00:00 set. Additionally, you receive a diagnostics message.
4.19 'Diagnostic entries' on page 89
n With the operating mode switch you may switch the CPU between STOP and RUN.
n During the transition from STOP to RUN the operating mode START-UP is driven by
the CPU.
n Placing the switch to MR (Memory Reset), you request an overall reset with following
load from memory card, if a project there exists.
SF FC SD
red yellow yellow
BB ● ●
● ● ●
● ● ○
● ○ ○
● ○ ○
X X X
X X X
X X X
Meaning
Flickers: Firmware is loaded.
Initialization: Phase 1
Initialization: Phase 2
Initialization: Phase 3
Initialization: Phase 4
CPU is in STOP state.
CPU is in start-up state.
Blinking with 2Hz: The RUN LED blinks during start-up (OB 100)
at least for 3s.
Blinking with 10Hz: Activation of a new hardware configuration
Hardware description
Structure > LEDs
Ä Chapter
43