Wiring; Wiring Cpu 01Xc - YASKAWA CPU 013C Manual

Basics and mounting
Wiring > Wiring CPU 01xC

2.5 Wiring

2.5.1 Wiring CPU 01xC

CPU connector
Data
Wiring procedure
Insert wire
Remove wire
20
For wiring the CPU 01xC has removable connectors. With the wiring of the connectors a
"push-in" spring-clip technique is used. This allows a quick and easy connection of your
signal and supply lines. The clamping off takes place by means of a screwdriver.
U 240V AC / 30V DC
max
I 10A
max
Cross section
0.08 ... 1.5mm
Stripping length 10mm
Use for wiring rigid wires respectively use wire sleeves. When using stranded wires you
have to press the release button with a screwdriver during the wiring.
1 Labeling on the casing
2 Pin no. at the connector
3 Release button
4 Connection hole for wire
The wiring happens without a tool.
Determine according to the casing labelling the connection position and insert
through the round connection hole of the according contact your prepared wire until
it stops, so that it is fixed.
ð By pushing the contact spring opens, thus ensuring the necessary contact pres-
sure.
The wire is to be removed by means of a screwdriver with 2.5mm blade width.
1. Press with your screwdriver vertically at the release button.
ð The contact spring releases the wire.
2. Pull the wire from the round hole.
2 (AWG 28 ... 16)
HB300 | CPU | 013-CCF0R00 | en | 16-40
VIPA System SLIO