Table of Contents
Advertisement
Configuration with VIPA SPEED7 Studio
SPEED7 Studio - Hardware configuration - Ethernet PG/OP channel
Assembly and commis-
sioning
"Initialization"
202
n
For online access to the CPU via the Ethernet PG/OP channel, valid IP address
parameters have to be assigned to this. This is called "initialization".
n
This can be done with the SPEED7 Studio.
1.
Install your System SLIO with your CPU.
2.
Wire the system by connecting cables for voltage supply and signals.
3.
Connect the one of the Ethernet jacks (X1, X2) of the Ethernet PG/OP channel to
Ethernet.
4.
Switch on the power supply.
ð After a short boot time the CP is ready for communication. He possibly has no
IP address data and requires an initialization.
You get valid IP address parameters from your system administrator. The assignment of
the IP address data happens online in the SPEED7 Studio with the following proceeding:
1.
Ethernet PG/OP
Determine the current Ethernet (MAC) address of your Ethernet PG/OP channel.
This can be found at the front of the CPU labelled as "MAC PG/OP: ...".
2.
Start the SPEED7 Studio with your project.
3.
Click in the Project tree at 'Devices and networking' .
ð You will get a graphical object view of your CPU.
4.
Click at the network 'PG_OP_Ethernet' .
VIPA System SLIO
HB300 | CPU | 013-CCF0R00 | en | 16-40
Advertisement
Table of Contents
