YASKAWA CPU 013C Manual page 211

VIPA System SLIO
9.6.6.2 Parametrization in SPEED7 Studio
9.6.6.2.1 'I/O addresses'
Sub module Input address
Count 816
820
824
828
Sub module Output address
Count 816
820
824
828
9.6.6.2.2 Basic parameters
Select interrupt
9.6.6.2.3 'Channel x:'
Operating mode
HB300 | CPU | 013-CCF0R00 | en | 16-40
Access
DINT
DINT
DINT
DINT
Access
DWORD
DWORD
DWORD
DWORD
Via 'Basic parameters' you can reach 'Select interrupt' . Here you can define the inter-
rupts the CPU will trigger. The following parameters are supported:
n None: The interrupt function is disabled.
n Process: The following events of the frequency measurement can trigger a hardware
interrupt (selectable via 'Frequency counting' ):
– End of measurement
n Diagnostics+process: A diagnostics interrupt is only triggered when a hardware inter-
rupt was lost.
Select via 'Channel' the channel and select for frequency measurement via 'Operating
mode' the operating mode 'Frequency counting' . Default values and structure of this
dialog box depend on the selected 'Operating mode' . The following parameters are sup-
ported:
1 Integration time
2 Counting pulse
3 SW gate
4 Evaluated frequency
Configuration with VIPA SPEED7 Studio
Deployment I/O periphery > Frequency measurement
Assignment
Channel 0: Counter value / Frequency value
Channel 1: Counter value / Frequency value
Channel 2: Counter value / Frequency value
Channel 3: Counter value / Frequency value
Assignment
reserved
reserved
reserved
reserved
211