Table of Contents
Advertisement
VIPA System SLIO
4.10.4
Web page with selected module
Info
Data
Parameter
4.11
Operating modes
4.11.1
Overview
Operating mode STOP
HB300 | CPU | 013-CCF0R00 | en | 16-40
Here product name, order number, serial number, firmware version and hardware state
number of the according module are listed.
Here the address and the state of the inputs respectively outputs are listed. Please note
with the outputs that here exclusively the states of outputs can be shown, which are
within the OB 1 process image.
With parameterizable modules e.g. analog modules the parameter setting is shown here.
These come from the hardware configuration.
The CPU can be in one of 3 operating modes:
n
Operating mode STOP
n
Operating mode START-UP
(OB 100 - restart / OB 102 - cold start *)
n
Operating mode RUN
Certain conditions in the operating modes START-UP and RUN require a specific reaction
from the system program. In this case the application interface is often provided by a call
to an organization block that was included specifically for this event.
n
The application program is not processed.
n
If there has been a processing before, the values of counters, timers, flags and the
process image are retained during the transition to the STOP mode.
n
Command output disable (BASP) is activated this means the all digital outputs are
disabled.
n
RUN-LED off
n
STOP-LED on
Deployment CPU 013-CCF0R00
Operating modes > Overview
77
Advertisement
Table of Contents
