YASKAWA CPU 013C Manual page 207

VIPA System SLIO
9.6.5.2 Parametrization in SPEED7 Studio
9.6.5.2.1 'I/O addresses'
Sub module Input address
Count 816
820
824
828
9.6.5.2.2 Basic parameters
Select interrupt
9.6.5.2.3 'Channel x'
Operating mode
Counter
Operating mode
HB300 | CPU | 013-CCF0R00 | en | 16-40
Access
DINT
DINT
DINT
DINT
Via 'Basic parameters' you can reach 'Select interrupt' . Here you can define the inter-
rupts the CPU will trigger. The following parameters are supported:
None: The interrupt function is disabled.
n
Process: The following events of the counter can trigger a hardware interrupt (select-
n
able via 'Count' ):
– Hardware gate opening
– Hardware gate closing
– On reaching the comparator
– on Counting pulse
– on overflow
– on underflow
n Diagnostics+process: A diagnostics interrupt is only triggered when a hardware inter-
rupt was lost.
Select via 'Channel' the channel select via 'Operating' the counter operating mode. The
following counter operating modes are supported:
n Not parametrized: Channel is de-activated
n Count endless
n Count once
n Count periodical
Default values and structure of this dialog box depend on the selected 'Operating mode' .
Configuration with VIPA SPEED7 Studio
Assignment
Channel 0: Counter value / Frequency value
Channel 1: Counter value / Frequency value
Channel 2: Counter value / Frequency value
Channel 3: Counter value / Frequency value
Deployment I/O periphery > Counter
207