YASKAWA CPU 013C Manual page 39

VIPA System SLIO
X1/X2: Ethernet PG/OP
channel
X3: MPI(PtP) interface
HB300 | CPU | 013-CCF0R00 | en | 16-40
8pin RJ45 jack:
n The RJ45 jack serves as interface to the Ethernet PG/OP channel.
n This interface allows you to program respectively remote control your CPU and to
access the internal web server.
Configurable connections are possible.
n
n The connection happens via an integrated 2-port switch
n DHCP respectivle the assignment of the network configuration by specifying a DHCP
server is supported.
Default diagnostic addresses: 2025 ... 2040
n
For online access to the CPU via Ethernet PG/OP channel, you have to assign IP
n
address parameters to this.
Ä Chapter 4.6 'Hardware configuration - Ethernet PG/OP channel' on page 64
Ä Chapter 7 'Deployment PG/OP communication - productive' on page 171
9pin SubD jack: (isolated)
The interface supports the following functionalities, which are switch able:
n MPI (default / after overall reset)
The MPI interface serves for the connection between programming unit and CPU. By
means of this the project engineering and programming happens. In addition MPI
serves for communication between several CPUs or between HMIs and CPU.
Standard setting is MPI address 2.
n PtP
The RS485 interface can be switched to PtP functionality
specific CPU parameters' on page 70. Using the PtP functionality the RS485 interface
is allowed to connect via serial point-to-point connection to different source res. target
systems.
The following protocols are supported:
– ASCII
– STX/ETX
– 3964R
– USS
– Modbus master (ASCII, RTU)
n PROFIBUS DP (option)
The PROFIBUS functionality of this interface can be activated by configuring the sub
module X1 'MPI/DP' of the CPU in the hardware configuration.
PROFIBUS communication' on page 186
To switch the interface X3 MPI(PtP) to PROFIBUS functionality you have
to activate the according bus functionality by means of a VSC storage
media from VIPA. By plugging the VSC storage card and then an overall
reset the according functionality is activated.
ment storage media - VSD, VSC' on page 83
Hardware description
Structure > Interfaces
Ä Chapter 4.8 'Setting VIPA
Ä Chapter 8 'Option:
Ä Chapter 4.15 'Deploy-
39